| About |
|---|
| Type: Estane® 58370 TPU is an 80A Polyether-Type Thermoplastic Polyurethane. Features: Halogenated flame retardant compound Uses: Extrusion – Wire and cable and general application where flame retardant properties are needed&& |
| Product Description | |
|---|---|
| Supplier | Lubrizol Advanced Materials |
| Generic | TPU-醚 |
| Material Status | Commercial: Active |
| Features | Good flexibility,Flame Characteristics,Grease resistance,Solvent resistance,Halogenated,V-2 |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.18 | g/cm³ | ASTM D792 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D412 | ||
| Fracture, 0.762 mm | 29.7 | MPa | ASTM D412 |
| 100% strain, 0.762 mm | 4.80 | MPa | ASTM D412 |
| 300% strain, 0.762 mm | 6.60 | MPa | ASTM D412 |
| Tensile strain | |||
| Fracture, 0.762 mm | 690 | % | ASTM D412 |
| tear strength | |||
| 0.762 mm | 59.8 | kN/m | ASTM D624 |
| cracking | 18 | kN/m | ASTM D470 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Glass transition temperature | -50.0 | ℃ | DSC |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | V-2 | UL 94 | |
| Extreme oxygen index | 28 | % | ASTM D2863 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 5 seconds | 77 to 83 | ASTM D2240 | |
| Taber abraser | |||
| 1000 cycles, 1000 g, CS-17 wheels | 3.00 | mg | ASTM D3389 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 104 | °C | |
| Drying time | 2.0 to 4.0 | hr | |
| Recommended maximum moisture content | 0.020 | % | |
| Barrel 1 zone temperature | 175 | °C | |
| Barrel 2 zone temperature | 180 | °C | |
| Barrel 3 zone temperature | 188 | °C | |
| Barrel 4 zone temperature | 194 | °C | |
| Connector temperature | 194 | °C | |
| Melt temperature | 188 | °C | |
| Nozzle temperature | 188 to 194 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |