| About |
|---|
| QAMAR FD21HS is a Linear Low Density Polyethylene material. It is available in North America for blown film or cast film. Important attributes of QAMAR FD21HS are: Antiblock Clarity Slip Typical application of QAMAR FD21HS: Film&& |
| Product Description | |
|---|---|
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Good Clarity,Smoothness,High anti-blocking |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | 2.0 | g/10min | ISO 1872-2 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 122 | ℃ | ISO 11357-3 |
| Vicat Softening Temp | |||
| A50 | 100 | ℃ | ISO 306/A50 |
| Embrittlement temperature | <-70 | ℃ | ISO 974 |
| Linear coefficient of thermal expansion |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 54 | ISO 868 | |
| tensile strength | 40 | MPa | ISO 527-3 |
| Tensile modulus | 190 | MPa | ISO 527-3 |
| Tensile strain | 600 | % | ISO 527-3 |
| tear strength | 30 | N | ISO 6383-2 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion molding conditions | Nominal value | Unit | Test method |
| Zone 1 temperature | 170 | °C | |
| Zone 5 temperature | 190 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |