TECHNYL® B 218 MX30 NATURAL

About
TECHNYL® B 218 MX30 Natural is a polyamide 66/6, reinforced with 30% of mineral filler, heat stabilized, for injection moulding.&&

Product Description
Supplier	DOMO
Generic	PA66/6
Material Status	Commercial: Negative
Features	Good surface appearance,Low warping,Heat Stabilized
Availabilitys	North America
Process Methods	Injection Molding

Technical Data

Process Conditions
Injection	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	255 to 265	°C
Temperature in the middle of the barrel	260 to 270	°C
Front temperature of material barrel	270 to 280	°C
Mold temperature	70 to 100	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.