| About |
|---|
| Alkatane GF7660 is a medium molecular weight extrusion blow moulding grade of High Density Polyethylene. This grade exhibits good ESCR and good toughness. Alkatane GF7660 is designed primarily for extrusion blow moulding of small to medium sized containers. Typical applications include detergent and pharmaceutical bottles. Suitability for use in any application should be determined by appropriate performance testing.&& |
| Product Description | |
|---|---|
| Supplier | Qenos |
| Generic | MMW-HDPE |
| Material Status | Commercial: Active |
| Features | Good flexibility,Food contact compliance,High ESCR |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.953 | g/cm³ | ASTM D792 |
| Melt Flow Rate | ASTM D1238 | ||
| 190℃，2.16kg | 0.40 | g/10min | ASTM D1238 |
| 190℃，5.0kg | 1.6 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | 200 | hr | ASTM D1693B |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 30.0 | MPa | ASTM D638 |
| Bending modulus | 1200 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| -30℃ | 950 | J/m | ASTM D256-A |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type IV, 2.0 in/min |
| 3. 0.50 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |