| About |
|---|
| Dryflex V Thermoplastic Vulcanisate (TPV) compounds are high performance materials designed for demanding applications where improved durability, heat or fluid resistance are required.&& |
| Product Description | |
|---|---|
| Generic | TPV |
| Material Status | Commercial: Negative |
| Features | Weather resistance is good,Excellent Processability,Good Dimensional Stability,Renewable resources,Acidproof,Good bond,Fatigue resistance,Grease resistance,Solvent resistance |
| Availabilitys | Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.970 | g/cm³ | ISO 2781 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 65 | ISO 868 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 6.50 | MPa | ISO 37 |
| 100% strain | 2.50 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 500 | % | ISO 37 |
| tear strength | 24 | kN/m | ISO 34-1 |
| Compression deformation | ISO 815 | ||
| 23℃，24 hr | 20 | % | ISO 815 |
| 70℃，24 hr | 29 | % | ISO 815 |
| 100℃，24 hr | 36 | % | ISO 815 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 3.0 | hr | |
| Barrel rear temperature | 160 to 190 | °C | |
| Barrel middle temperature | 170 to 200 | °C | |
| Barrel front temperature | 180 to 210 | °C | |
| Nozzle temperature | 190 to 220 | °C | |
| Mold temperature | 15 to 50 | °C | |
| Drying temperature | 80 | °C | |
| Drying time | 3.0 | hr | |
| Barrel 1 zone temperature | 160 to 190 | °C | |
| Barrel 2 zone temperature | 170 to 200 | °C | |
| Barrel 3 zone temperature | 180 to 200 | °C | |
| Barrel 4 zone temperature | 180 to 210 | °C | |
| Nozzle temperature | 190 to 220 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method C, Crescent |
| 3. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |