TPSiV™ 3111-70A

About
TPSiV™ 3111-70A is a Thermoplastic Silicone Vulcanizate (TPSiV) product. It can be processed by injection molding and is available in Africa & Middle East, Asia Pacific, Europe, Latin America, or North America. Applications of TPSiV™ 3111-70A include consumer goods, electrical/electronic applications, food contact applications, plumbing/piping/potable water and sealing applications. Characteristics include: Good Adhesion Good Flexibility Heat Resistant Wear Resistant&&

About

TPSiV™ 3111-70A is a Thermoplastic Silicone Vulcanizate (TPSiV) product. It can be processed by injection molding and is available in Africa & Middle East, Asia Pacific, Europe, Latin America, or North America. Applications of TPSiV™ 3111-70A include consumer goods, electrical/electronic applications, food contact applications, plumbing/piping/potable water and sealing applications. Characteristics include: Good Adhesion Good Flexibility Heat Resistant Wear Resistant&&

Product Description
Generic	TPSiV
Material Status	Commercial: Active
Features	Hydrolysis stability,High Heat Resistance,Low temperature toughness,Good wear resistance,Agglomerability
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.15	g/cm³	ISO 1183
Shrinkage rate	1.0 to 3.0	%	Multiple Standards

elastic body	Nominal value	Unit	Test method
tensile strength
yield	15.0	MPa	ISO 37
Tensile strain
fracture	600	%	ISO 37
tear strength	45	kN/m	ISO 34-1
Compression deformation
23℃，22 hr	20	%	ISO 815

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shore A, 3 seconds	70		ISO 868

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	65 to 80	°C
Drying time	2.0 to 4.0	hr
Barrel rear temperature	185 to 195	°C
Barrel middle temperature	190 to 200	°C
Barrel front temperature	200 to 215	°C
Nozzle temperature	205 to 220	°C
Processing (melt) temperature	215	°C
Mold temperature	30 to 60	°C
Injection speed	Moderate-Fast

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.