| About |
|---|
| 不含邻苯二甲酸盐 PVC ，环保和无毒，优良的热稳定性，印刷性好，透明/自然的颜色，可再循环材料，柔软的触感 |
| Product Description | |
|---|---|
| Supplier | Kingfa |
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Features | Good Printability,Heat Stabilized |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 15 seconds | 91 | A 级 | ASTM D2240 |
| tensile strength | |||
| 50 mm/min | 18.5 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 50 mm/min | 186 | % | ASTM D638 |
| other | Nominal value | Unit | Test method |
|---|
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 1.32 | g/cm³ | ASTM D792 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| Melt temperature | 140-160 | °C | |
| Temperature of the rear section of the barrel | 140-160 | °C | |
| Temperature in the middle section of the barrel | 150-170 | °C | |
| Temperature of the front section of the material barrel | 160-180 | °C | |
| Mold temperature | 30-50 | °C | |
| Upper limit of processing temperature | 200 | °C | |
| Injection molding speed | 中速或低速 | °C | |
| Pre-drying | 60-80°C，2h | ||
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |