ZYPEEK®770GHM

About

Product Description
Supplier	ZYPEEK
Generic	PEEK
Material Status	Commercial: Active

Technical Data
MECHANICAL	Nominal value	Unit	Test method
Shore hardness
23℃	82	D 级	ISO 868
Tensile strain
Fracture, 23 ℃	12	%	ISO 527
Bending modulus
23℃	3200	MPa	ISO 178
bending strength
Yield, 23 ℃	135	MPa	ISO 178
tensile strength
Yield, 23 ℃	88	MPa	ISO 527

PHYSICAL	Nominal value	Unit	Test method
Water absorption rate
23 ℃, 24hr, 3.2mm thick stretching rod	0.07	%	ISO 62-1
Equilibrium, 23 ℃	0.4	%	ISO 62-1
Shrinkage rate
MD	1.3	%	ISO 294-4
TD	1	%	ISO 294-4
Melt Flow Rate
380℃，5.0kg	10	g/10min	ISO 1133
Density
crystallization	1.34	g/cm³	ISO 1183

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	7.5	kJ/m²	ISO 180/A
Notched impact strength of cantilever beam	无断裂	kJ/m²	ISO 180/U

THERMAL	Nominal value	Unit	Test method
melting point	343	℃	ISO 11357
Tg (starting)	143	℃	ISO 11357
Hot deformation temperature
1.8 Mpa	152	℃	ISO 75-f

Electrical performance	Nominal value	Unit	Test method
Volume resistivity
23 ℃，1V	10^16	ohms·cm	IEC 60093

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.