| About |
|---|
| Haysite BMC 20000 is a Thermoset Polyester product filled with 15% glass fiber. It is available in North America. Primary characteristic: flame rated.&& |
| Product Description | |
|---|---|
| Generic | 热固性聚酯 |
| Material Status | Commercial: Active |
| Features | V-0 |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.95 | g/cm³ | |
| Shrinkage rate | |||
| MD | 0.25 | % | |
| Water absorption rate | |||
| balance | 0.10 | % | ASTM D570 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 44.8 | MPa | ASTM D638 |
| bending strength | 103 | MPa | ASTM D790 |
| compressive strength | 89.6 | MPa | ASTM D695 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 210 | J/m | ASTM D256 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | |||
| In oil | 16 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 60 Hz | 0.0550 | ASTM D150 | |
| Dissipation factor | |||
| 60 Hz | 0.029 | ASTM D150 | |
| Arc resistance | 190 | sec | ASTM D495 |
| Inclined（Plane Tracking） | 600 | min | ASTM D2303 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | V-0 | UL 94 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Temperature level | 130 | ℃ |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method A (Short-Time) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |