| About |
|---|
| Exact 4151 is an ethylene-based hexene plastomer produced using ExxonMobil Chemical’s EXXPOL® Catalyst Technology. Exact 4151 is designed for both monolayer and multilayer coextruded cast and blown film applications requiring low sealing temperatures, high oxygen transmission and high toughness. Typical applications include seal layers for lamination films used in meat, poultry and produce packaging.&& |
| Product Description | |
|---|---|
| Supplier | ExxonMobil |
| Generic | Polyolefin Elastomer |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good Clarity,High impact resistance,Ethanol tolerance,Gamma radiation,E-beam disinfection,Biocompatible,No BPA,Solvent resistance,High ESCR,Ethylene oxide disinfection,Agglomerability |
| Availabilitys | North America |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| film | Nominal value | Unit | Test method |
| Secant modulus | |||
| 1% secant, TD | 63.8 | MPa | ASTM D882 |
| 1% secant, MD | 55.6 | MPa | ASTM D882 |
| tensile strength | |||
| TD, fracture | 69.4 | MPa | ASTM D882 |
| TD, yield | 4.07 | MPa | ASTM D882 |
| MD, fracture | 85.2 | MPa | ASTM D882 |
| MD, yield | 5.45 | MPa | ASTM D882 |
| Tensile strain | |||
| TD, fracture | 640 | % | ASTM D882 |
| TD, yield | 8.5 | % | ASTM D882 |
| MD, fracture | 410 | % | ASTM D882 |
| MD, yield | 12 | % | ASTM D882 |
| Drop hammer impact | 940 | g | ASTM D1709-A |
| Elmandorf tear strength | |||
| MD | 90 | g | ASTM D1922 |
| tear strength | |||
| TD | 280 | g | ASTM D1922 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 76.0 | ℃ | ASTM D1525 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| gloss | |||
| 45° | 93 | ASTM D2457 | |
| Haze | 0.40 | % | ASTM D1003 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Value reported is an estimate based on ExxonMobil’s correlation from melt flow rate data measured at other standard conditions, based on ASTM D 1238. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |