Duramide PA6GF20

About
Duramide PA6GF20 is a nylon 6 based resin compound with 20 percent glass fiber reinforcement by volume. Available in black, natural, and custom colors. Available in North America, Europe, and Pacific. Data sheet values below are for all colors.&&

Product Description
Generic	PA6
Material Status	Commercial: Active
Availabilitys	North America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.30	g/cm³	ASTM D792
Shrinkage rate
MD：3.2 mm	0.40	%	ASTM D955
Water absorption rate
24hr	1.4	%	ASTM D570

MECHANICAL	Nominal value	Unit	Test method
tensile strength
fracture	141	MPa	ASTM D638
Tensile strain
fracture	3.5	%	ASTM D638
Bending modulus	6890	MPa	ASTM D790
bending strength	212	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	85	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	204	℃	ASTM D648

Electrical performance	Nominal value	Unit	Test method
Volume resistivity	1.0E+15	ohms·cm	ASTM D257

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	82	°C
Drying time	4.0	hr
Barrel rear temperature	260 to 304	°C
Barrel middle temperature	260 to 304	°C
Barrel front temperature	260 to 304	°C
Processing (melt) temperature	243 to 271	°C
Mold temperature	66 to 93	°C
Back pressure	0.00 to 0.345	MPa
Screw speed	30 to 60	rpm

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.