| About |
|---|
| The basic grade in the broad range of styrene-butadiene block copolymers from Asahi Kasei. A styrenic thermoplastic elastomer with superior elasticity, styrenic resins compatibility, moldability, adhesive performance, and asphalt blend characteristics. It is supplied in pellet form. Applications: Styrenic resins modifier, imparting increased impact strength, for food containers. Also used as adhesives and sealants component, and as asphalt modifier for reduced temperature sensitivity and heightened cohesive and adhesive strength.&& |
| Product Description | |
|---|---|
| Supplier | Asahi Kasei |
| Generic | SBS |
| Material Status | Commercial: Active |
| Features | Excellent Processability,High impact resistance,High elastic,Block Copolymer,Good bond |
| Availabilitys | Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.950 | g/cm³ | ISO 1183 |
| Melt Flow Rate | ISO 1133 | ||
| 190℃，2.16kg | 2.6 | g/10min | ISO 1133 |
| 200℃，5.0kg | 13 | g/10min | ISO 1133 |
| Styrene/Butadiene | 40/60 | Internal Method | |
| viscosity | |||
| 25% toluene solution, 23 ℃ | 0.65 | Pa·s | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 23 ℃, 2.00 mm, molded | 85 | ISO 7619 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, 23 ℃, 2 mm | 14.0 | MPa | ISO 37 |
| 300% strain, 23 ℃, 2 mm | 2.50 | MPa | ISO 37 |
| Tensile strain | |||
| Fracture, 23 ℃, 2 mm | 1100 | % | ISO 37 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type 1A |
| 3. Compression Molded |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |