| About |
|---|
| ExxonMobil EN 33331 is a very high flow, 32.5% nBA copolymer suitable for use in hot melt adhesives and sealants.&& |
| Product Description | |
|---|---|
| Supplier | ExxonMobil |
| Generic | EBA |
| Material Status | Commercial: Active |
| Availabilitys | North America,Latin America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 190℃，2.16kg | 330 | g/10min | ASTM D1238 |
| Butyl acrylate composition | 32.5 | wt% | ExxonMobil Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds | 54 | ASTM D2240 | |
| tensile strength | |||
| fracture | 1.31 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 98 | % | ASTM D638 |
| Bending modulus | |||
| 1% secant | 7.10 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Melt Index reported is an estimate based on ExxonMobil’s correlation from melt flow rate data measured at other standard conditions. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |