Perfactory® E-Partial

About
EnvisionTEC‘s E-Partial chemistry was developed for building partials where some flex is required without damage. E-Partial material maintains flexural strength to ensure clasp flex without breakage. The stiffness of E-Partial allows for production of a very hard retention grid and super tight thin clasps to deliver a metal partial with the perfect fit every time. The Perfactory® 4 DDP 3D printer gives you high accuracy printing with unmatched speed. Printing partials is a snap in the E-Partial material and the Perfactory® 4 DDP 3D Printer. Unattended production means the machine can work while you are away. It will even turn itself off after completing a build. Applications Dental Recommended Machines: Perfactory® 4 DDP Series&&

About

EnvisionTEC‘s E-Partial chemistry was developed for building partials where some flex is required without damage. E-Partial material maintains flexural strength to ensure clasp flex without breakage. The stiffness of E-Partial allows for production of a very hard retention grid and super tight thin clasps to deliver a metal partial with the perfect fit every time. The Perfactory® 4 DDP 3D printer gives you high accuracy printing with unmatched speed. Printing partials is a snap in the E-Partial material and the Perfactory® 4 DDP 3D Printer. Unattended production means the machine can work while you are away. It will even turn itself off after completing a build. Applications Dental Recommended Machines: Perfactory® 4 DDP Series&&

Product Description
Generic	SMMA
Material Status	Commercial: Active
Features	Good Rigidity,Good flexibility,Good surface appearance
Availabilitys	North America,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.10 to 1.11	g/cm³
viscosity
25℃	0.76	Pa·s

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature			ASTM D648
0.45 MPa, unannealed	130	℃	ASTM D648
1.8 MPa, unannealed	78.0	℃	ASTM D648

MECHANICAL	Nominal value	Unit
Shore hardness
Shaw’s D	89
tensile strength	57.0	MPa
Tensile strain
fracture	3.6	%
Bending modulus	3160	MPa
bending strength	129	MPa

Notes
1. Typical properties: these are not to be construed as specifications.
2. No heat treatment necessary
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.