| About |
|---|
| LOCTITE® EA E-60NC is a flowable, industrial grade epoxy potting compound with extended work life. Once mixed, the two-part epoxy cures at room temperature to form a rigid, black encapsulant that is non-corrosive to metallic components on PC Boards and electronic assemblies. The fully cured epoxy provides excellent environmental and chemical resistance, and acts as an electrical insulator. TYPICAL APPLICATIONS Designed for bonding, potting and encapsulating electrical components which are sensitive to corrosion. Used in electronic applications, for component attachment to boards, housing assembly and potting.&& |
| Product Description | |
|---|---|
| Supplier | Henkel |
| Generic | 环氧树脂 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good liquidity,Solvent resistance,Insulation,Room Temperature Cure |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| THERMAL | Nominal value | Unit | Test method |
| Glass transition temperature | 55.0 | ℃ | |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 22 | kV/mm |
| Uncured Properties | Nominal value | Unit | Test method |
|---|---|---|---|
| colour | |||
| — | Black | ||
| — | Yellow | ||
| Weight Mix Ratio (PBW) | |||
| Resin | 100 | ||
| Hardener | 91 | ||
| Volume Mixing Ratio (PBV) | |||
| Resin | 1.0 | ||
| Hardener | 1.0 | ||
| Density | |||
| 25℃ | 0.998 | g/cm³ | |
| 25℃ | 1.05 | g/cm³ | |
| 25℃ | 1.10 | g/cm³ | |
| flash point | |||
| — | > 93.0 | ℃ | |
| viscosity | |||
| 25℃ | 6.2 | Pa·s | |
| 25℃ | 13 | Pa·s | |
| Tack Free Time | 180 | min | |
| storage stability | |||
| 25 ℃ | 60 | min |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 85 | ASTM D1706 | |
| tensile strength | 46.9 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 8.0 | % | ASTM D638 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Resin |
| 3. Hardener |
| 4. Mixed |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |