| About |
|---|
| Formolene® 3435E is a high melt flow, random copolymer polypropylene with fast cycle time and easy mold release. It is designed for injection molding including thin wall applications requiring a higher level of impact resistance. Its clarity and low yellow index makes it an excellent choice for ‘see-through’ house wares and rigid packaging. Formolene® 3435E meets the requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520, covering safe use of polyolefin articles and components of articles intended for direct food contact. This material is free of animal-derived content.&& |
| Product Description | |
|---|---|
| Supplier | fpc-tw |
| Generic | PP copolymer |
| Material Status | Commercial: Active |
| Features | High impact resistance,High liquidity,Quick molding cycle,Good stripping performance |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 35 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23 ℃, injection molding | 85 | J/m | ASTM D256-A |
| Drop hammer impact | |||
| 23 ℃, injection molding | 25.0 | J | ASTM D5420 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed, injection molded | 71.0 | ℃ | ASTM D648 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Haze | |||
| Injection molded film | 10 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, injection molding | 25.5 | MPa | ASTM D638 |
| Tensile strain | |||
| Yield, injection molding | 16 | % | ASTM D638 |
| Bending modulus | |||
| 1% cut, injection molding | 862 | MPa | ASTM D790 |
| Rockwell hardness | |||
| R-level | 100 | ASTM D785 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 3. 0.051 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |