| About |
|---|
| Product Description | |
|---|---|
| Generic | ABS |
| Material Status | Commercial: Active |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | |||
| 23℃ | 1.05 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 220℃，10.0kg | 5.7 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| 3.2 mm | 0.4-0.7 | % | ASTM D-955 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃，3.2mm | 406 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed, 3.2 mm | 86.0 | ℃ | ASTM D648 |
| Annealing, 80 ℃ × 8 hours | 96 | ℃ | ASTM D648 |
| Vicat Softening Temp | 106 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| 23 ℃, R-grade | 96 | ASTM D785 | |
| tensile strength | |||
| 23℃ | 36 | MPa | ASTM D638 |
| Bending modulus | |||
| 23℃ | 1960 | MPa | ASTM D790 |
| bending strength | |||
| 23℃ | 62 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| drying temperature | 80 to 85 | °C | |
| Drying time | 2.0 to 3.0 | hr | |
| Processing (melt) temperature | 190 to 230 | °C | |
| Mold temperature | 40 to 80 | °C | |
| Injection pressure | 68.6 to 108 | MPa | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |