| About |
|---|
| Epalex PDR 7386/3 UV3 is a thermoplastic rubber modified polypropylene compound. It is a medium to high flow injection moulding grade developed for maximum flexibility, low surface hardness, excellent low temperature impact strength and good tear strength. It is stabilized for continuous outdoor exposure.&& |
| Product Description | |
|---|---|
| Generic | PP not specified |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good flexibility,High impact resistance,Low Hardness,Good tear strength,Moderate liquidity,low-temperature impact resistance |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.888 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 10 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD：3.0 mm | 0.30 to 0.80 | % | ASTM D955 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| -20℃，3mm | 无断裂 | ||
| 0℃，3mm | 无断裂 | ||
| 23℃，3mm | 无断裂 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed, 3.0 mm | 40.0 | ℃ | ASTM D648 |
| Linear coefficient of thermal expansion | |||
| MD：-30~30℃，3.00 mm | 1.0E-4 | 1/℃ | ASTM D696 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore D, 3.00 mm | 37 | ||
| Shore D, 15 seconds, 3.00 mm | 29 | ||
| tensile strength | |||
| 3 mm | 7.00 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 3 mm | 450 | % | ASTM D638 |
| Bending modulus | |||
| 3 mm | 230 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 2.0 | hr | |
| Proposed maximum recycled material ratio | 10 | % | |
| Processing (melt) temperature | 200 to 260 | °C | |
| Mold temperature | 20 to 60 | °C | |
| Injection speed | 中等偏快 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |