| About |
|---|
| The AD/PA Series is your material solution for applications with excellent adhesion to PA. The compounds are available in natural and black colors. Typical applications Cable clips Function and design elements Grommets Handles (hand tools and power tools etc.) Seals Thumb wheels Material advantages Adhesion to PA6 and PA6.6 up to 50 % glass fiber Easy coloring (compounds in natural colors) Excellent adhesion Excellent processing behavior Insert molding possible Pleasant surface feel (Soft touch) UL 94 HB listed Wide hardness range 25-80 Sh A&& |
| Product Description | |
|---|---|
| Supplier | KRAIBURG |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good bond,Soft,HB |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.15 | g/cm³ | ISO 1183 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 3.00 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 400 | % | ISO 37 |
| tear strength | 16 | kN/m | ISO 34-1 |
| Compression deformation | ISO 815 | ||
| 23℃，72 hr | 29 | % | ISO 815 |
| 70℃，24 hr | 80 | % | ISO 815 |
| 100℃，24 hr | 81 | % | ISO 815 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 58 | ISO 7619 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | HB | UL 94 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Adhesion to PA6 | 18.0 | kN/m | Renault D41/1916 |
| Adhesion to PA66 | 11.0 | kN/m | Renault D41/1916 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 60 to 80 | °C | |
| Drying time | 2.0 to 4.0 | hr | |
| Barrel rear temperature | 230 to 245 | °C | |
| Barrel middle temperature | 250 to 260 | °C | |
| Barrel front temperature | 260 to 270 | °C | |
| Mold temperature | 40 to 60 | °C | |
| Injection pressure | 20.0 to 100 | MPa | |
| Back pressure | 2.00 to 10.0 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type S2, 7.9 in/min |
| 3. Method Bb, Angle (Nicked) |
| 4. Method A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |