| About |
|---|
| Greene 409 is a Fluorosilicone (Fluoro Si) product. It is available in North America.&& |
| Product Description | |
|---|---|
| Generic | 氟硅氧烷 |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.66 | g/cm³ | ASTM D792 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D1414 | ||
| fracture | 7.31 | MPa | ASTM D1414 |
| 50% strain | 3.17 | MPa | ASTM D1414 |
| 100% strain | 6.34 | MPa | ASTM D1414 |
| Tensile strain | |||
| fracture | 120 | % | ASTM D1414 |
| Compression deformation | |||
| 175℃，22 hr | 15 | % | ASTM D395 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Linear coefficient of thermal expansion | |||
| MD | 2.1E-4 | 1/℃ | ASTM E228 |
| Operating temperature | -52 to 81 | ℃ |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Rubber Classification | FVMQ | ||
| TR 10/50 | -65 | ℃ | ASTM D1329 |
| tear strength | |||
| Bie B | 17.5 | kN/m | ASTM D624 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 75 | ASTM D2240 | |
| Rockwell hardness | |||
| M-level | 78 | ASTM D785 | |
| friction coefficient | ASTM D1894 | ||
| With oneself – dynamic | 0.90 | ASTM D1894 | |
| With oneself – static | 1.6 | ASTM D1894 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method C |
| 3. 25% Deflection |
| 4. ASTM D1418 |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |