| About |
|---|
| Key Features: 35-mesh powder Good moldability Exceptional long term outdoor weatherability (UV15) Balance of toughness and rigidity Excellent low temperature impact Excellent environmental stress crack resistance, ESCR Compounded for uniform additive dispersion Natural as well as standard, custom or special effect colors available Stock colors may be available. See Stock color bulletin UL component recognition listing (E141240) Also available in pellet form as HM-305W&& |
| Product Description | |
|---|---|
| Generic | LMDPE |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability,Good flexibility,low-temperature impact resistance,High ESCR,HB |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.934 | g/cm³ | ASTM D792 |
| Apparent density | 0.34 | g/cm³ | ASTM D1895 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 5.0 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 100% non-ionic detergent, roll formed, F50 | 1000 | hr | ASTM D1693B |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, roll forming | 19.3 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, roll forming | 400 | % | ASTM D638 |
| Bending modulus | |||
| Tangent, roll forming | 793 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Izod notched impact strength | |||
| -40 ℃, roll forming | 92 | J | ARM |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed, roll formed | 42.0 | ℃ | ASTM D648 |
| 0.45 MPa, unannealed, roll formed | 63.0 | ℃ | ASTM D648 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | UL 94 | ||
| 1.50 mm | HB | UL 94 | |
| 3.00 mm | HB | UL 94 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Pourability | 30.0 | sec | ASTM D1895 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 35-mesh powder |
| 3. F50 |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |