Bayfit® 566 (90 Index, 3.3 pcf)

About
Bayfit 566 is a water-blown (MDI)/polyether based foam system used to manufacture high resilience (HR) cold-cure flex molded foam with medium to high load bearing properties. This system is characterized by good flow behavior in a wide variety of parts. Applications include office furniture, recreational seating, armrests and cushions. Bayfit 566 foam made at indices ranging from 80 to 105 typically passes the requirements of CAL-117 for flame resistance. Foams made at higher indices typically do not. As with any product, use of the Bayfit 566 system in a given application must be tested (including field testing, etc.) in advance by the user to determine suitability.&&

About

Bayfit 566 is a water-blown (MDI)/polyether based foam system used to manufacture high resilience (HR) cold-cure flex molded foam with medium to high load bearing properties. This system is characterized by good flow behavior in a wide variety of parts. Applications include office furniture, recreational seating, armrests and cushions. Bayfit 566 foam made at indices ranging from 80 to 105 typically passes the requirements of CAL-117 for flame resistance. Foams made at higher indices typically do not. As with any product, use of the Bayfit 566 system in a given application must be tested (including field testing, etc.) in advance by the user to determine suitability.&&

Product Description
Supplier	Covestro
Generic	PUR-脂肪族+MDI
Material Status	Commercial: Active
Features	Good liquidity
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.0529	g/cm³	ASTM D3574

MECHANICAL	Nominal value	Unit	Test method
tensile strength	0.110	MPa	ASTM D3574
Tensile strain
fracture	110	%	ASTM D3574
Tear resistance	446.4	g/2.5 cm	ASTM D3574

elastic body	Nominal value	Unit	Test method
Compression deformation			ASTM D3574
50%	3.3	%	ASTM D3574
70%	< 10	%	ASTM D3574

Supplementary information	Nominal value	Unit	Test method
IFD			ASTM D3574
25% R：102 mm	43.0	lb/50 in²	ASTM D3574
65% R：102 mm	109	lb/50 in²	ASTM D3574
SAG Factor（65%/25% IFD）	2.50		ASTM D3574

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.