Flexirene® MS 40 DA

About
Flexirene MS 40 DA is a linear low density polyethylene (LLDPE) with antioxidants, suitable for injection moulding application. Parts made by Flexirene MS 40 DA are characterised by a good balance between impact resistance and rigidity. Flexirene MS 40 DA is highly pure and it is suitable for all applications where good organoleptic properties are required. Main Application Flexirene MS 40 DA is recommended for the production of caps, closures, large sized articles, houseware and toys.&&

About

Flexirene MS 40 DA is a linear low density polyethylene (LLDPE) with antioxidants, suitable for injection moulding application. Parts made by Flexirene MS 40 DA are characterised by a good balance between impact resistance and rigidity. Flexirene MS 40 DA is highly pure and it is suitable for all applications where good organoleptic properties are required. Main Application Flexirene MS 40 DA is recommended for the production of caps, closures, large sized articles, houseware and toys.&&

Product Description
Generic	Linear low density polyethylene
Material Status	Commercial: Active
Features	High purity,High impact resistance,Food contact compliance,Inoxidizability,Good sensory characteristics.,Low density
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.930	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	27	g/10min	ISO 1133

THERMAL	Nominal value	Unit	Test method
Embrittlement temperature	< -70.0	℃	ASTM D746
Vicat Softening Temp	103	℃	ISO 306/A
Melting temperature	121	℃	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D, injection molding	52		ISO 868
tensile strength			ISO 527-2
Yield, injection molding	11.0	MPa
Fracture, injection molding	12.0	MPa
Tensile strain
Fracture, injection molding	> 500	%	ISO 527-2
Bending modulus
injection molding	300	MPa	ISO 178

Process Conditions
injection	Nominal value	Unit	Test method
Barrel rear temperature	160 to 210	°C
Barrel middle temperature	160 to 210	°C
Barrel front temperature	160 to 210	°C
Mold temperature	10.0 to 40.0	°C

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.