Nucrel® 30705

About
Nucrel® 30705 is an ethylene-acrylic acid copolymer resin available for use in conventional extrusion coating, coextrusion coating, and extrusion laminating equipment designed to process polyethylene resin. This resin may also be used in conventional blown and cast film extrusion and coextrusion equipment.&&

Product Description
Supplier	DOW
Generic	EAA
Material Status	Commercial: Active
Features	Good heat sealing,Low temperature heat sealing
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.93	g/cm³	ASTM D792
Melt Flow Rate
190℃，2.16kg	5.50	g/10min	ASTM D1238

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	85	℃	ASTM D1525
Melting temperature	107	℃	ASTM D4591

Process Conditions
Extrusion molding conditions	Nominal value	Unit	Test method
Drying temperature	50-90	°C
Drying time	2.0-4.0	Hr
Recommended moisture content	<=0.20	%
First zone temperature	160-240	°C
Zone 2 temperature	170-250	°C
Third zone temperature	180-260	°C
Fourth zone temperature	190-270	°C
Fifth zone temperature	200-280	°C
Die temperature	210-290	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.