PLUSTEK PB300G5BK11

About
PLUSTEK PB300G5BK11 is Black, 25% Glass Fiber Reinforced, UV Stabilized,Improved Surface Appearance POLYAMIDE 6, Injection Molding Applications

Product Description
Supplier	Ram-On
Generic	PA6
Material Status	Commercial: Active
Features	Weather resistance is good,Good surface appearance
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.30	g/cm³	ISO 1183
Shrinkage rate
TD：2.0 mm	0.50 to 0.90	%	Internal Method
MD：2.0 mm	0.20 to 0.60	%	Internal Method
Water absorption rate
Saturation, 23 ℃	7.0	%	ISO 62
Equilibrium, 23 ℃, 50% RH	2.0	%	ISO 62

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	7950	MPa	ISO 527-2/1A
Tensile stress	150	MPa	ISO 527-2/1A
Tensile strain
fracture	3.1	%	ISO 527-2/1A

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	10	kJ/m²	ISO 180

Process Conditions
Injection	Nominal value	Unit	Test method
Temperature at the rear of the barrel	220 to 240	°C
Temperature in the middle of the barrel	220 to 240	°C
Front temperature of material barrel	230 to 270	°C
Mold temperature	65 to 80	°C

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.