Perfactory® Press-E-Cast

About
EnvisionTEC’s Press-E-Cast is a wax-filled photopolymer material designed for use on the Pixcera and Perfactory® 4 DDP (Digital Dental Printer). Press-E-Cast produces highly detailed anatomy with crisp features. Its stiffness allows for the production of copings with extremely thin margins as well as full anatomical crowns. It is also possible to produce a perfectly fitting multiple unit bridge up to 16 units. Press-E-Cast has a very low thermal expansion during burnout and produces a high quality surface finish on cast or pressed parts. It is the only photopolymer-based material that actually melts during the burnout cycle, allowing for the material to melt out of the investment without leaving any ash residue which is a common problem associated with the burning of photopolymers used in competing technologies. Low material expansion allows the dental lab to rapid burnout and cast with any dental alloy avoiding flash due to micro-cracking in the investment. Pressing or casting in any material works well with conventional spruing techniques and investments. Average build times are under 2.5 hours for a full platform which allows the lab to produce several builds in an 8 hour shift. Unattended production means the machine can work while you are away. It will even turn itself off after completing a build. Applications Dental Recommended Machines: PixCera, Perfactory® 4 DDP&&

About

EnvisionTEC’s Press-E-Cast is a wax-filled photopolymer material designed for use on the Pixcera and Perfactory® 4 DDP (Digital Dental Printer). Press-E-Cast produces highly detailed anatomy with crisp features. Its stiffness allows for the production of copings with extremely thin margins as well as full anatomical crowns. It is also possible to produce a perfectly fitting multiple unit bridge up to 16 units. Press-E-Cast has a very low thermal expansion during burnout and produces a high quality surface finish on cast or pressed parts. It is the only photopolymer-based material that actually melts during the burnout cycle, allowing for the material to melt out of the investment without leaving any ash residue which is a common problem associated with the burning of photopolymers used in competing technologies. Low material expansion allows the dental lab to rapid burnout and cast with any dental alloy avoiding flash due to micro-cracking in the investment. Pressing or casting in any material works well with conventional spruing techniques and investments. Average build times are under 2.5 hours for a full platform which allows the lab to produce several builds in an 8 hour shift. Unattended production means the machine can work while you are away. It will even turn itself off after completing a build. Applications Dental Recommended Machines: PixCera, Perfactory® 4 DDP&&

Product Description
Generic	SMMA
Material Status	Commercial: Active
Features	Good Rigidity,Low CLTE,Good surface appearance,Good tear strength
Availabilitys	North America,Europe

Technical Data
MECHANICAL	Nominal value	Unit	Test method
tensile strength	56.0	MPa
Tensile strain
fracture	3.5	%
Bending modulus	3350	MPa
bending strength	115	MPa

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature	140	℃

Notes
1. Typical properties: these are not to be construed as specifications.
2. No heat treatment necessary
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.