3M™ Dyneon™ Fluoroelastomer FE 5520

About
3M™ Dyneon™ Fluoroelastomer FE 5520 is a terpolymer made from hexafluoropropylene, vinylidene fluoride and tetrafluoroethylene. FE 5520 has an incorporated bisphenol cure system. Special Features Composition: Low fluorine content terpolymer of vinylidene fluoride, hexafluoropropylene and tetrafluoroethylene Good compression set resistance Clean running with excellent mould release Process target: injection and transfer moulding Improved low temperature flexibility over standard dipolymers and terpolymers Proprietary incorporated cure technology Typical Applications 3M™ Dyneon™ Fluoroelastomer FE 5520 is ideal for automotive fuel system and oil seal applications, especially O-ring seals for fuel injection systems.&&

About

3M™ Dyneon™ Fluoroelastomer FE 5520 is a terpolymer made from hexafluoropropylene, vinylidene fluoride and tetrafluoroethylene. FE 5520 has an incorporated bisphenol cure system. Special Features Composition: Low fluorine content terpolymer of vinylidene fluoride, hexafluoropropylene and tetrafluoroethylene Good compression set resistance Clean running with excellent mould release Process target: injection and transfer moulding Improved low temperature flexibility over standard dipolymers and terpolymers Proprietary incorporated cure technology Typical Applications 3M™ Dyneon™ Fluoroelastomer FE 5520 is ideal for automotive fuel system and oil seal applications, especially O-ring seals for fuel injection systems.&&

Product Description
Generic	氟橡胶
Material Status	Commercial: Active
Features	Good Dimensional Stability,Good stripping performance,Terpolymer
Availabilitys	North America,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.80	g/cm³	Internal Method
Mooney viscosity
ML 1+10，121℃	26	MU	Internal Method
Fluorine content	66	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	76		ASTM D2240

elastic body	Nominal value	Unit	Test method
tensile strength	14.5	MPa	ASTM D412A
100% strain	6.60	MPa	ASTM D412A
Tensile strain
fracture	190	%	ASTM D412A
Compression deformation			ASTM D1414
200℃，70 hr	18	%	ASTM D1414
200℃，70 hr	12	%	ASTM D1414

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.