Eltex® MED PH23T630

About
Low Density Polyethylene for Healthcare applications Benefits & Features Eltex® MED PH23T630 is a LD-polyethylene for injection moulding having excellent flow properties allowing short cycle time or easy filling of long flow-paths. The moulded article is characterized by low degree of guilt-in stress & good flexibility Eltex® MED PH23T630 is produced according to good manufacturing practice and is additive-free. Applications Eltex® MED PH23T630 is recommended for injection moulding of: Flexible lids Caps and closures Pharmaceutical & diagnostic packaging Eltex® MED PH23T630 can be sterilized with Eto-treatment or with Gamma radiation up till 50 kGy&&

About

Low Density Polyethylene for Healthcare applications Benefits & Features Eltex® MED PH23T630 is a LD-polyethylene for injection moulding having excellent flow properties allowing short cycle time or easy filling of long flow-paths. The moulded article is characterized by low degree of guilt-in stress & good flexibility Eltex® MED PH23T630 is produced according to good manufacturing practice and is additive-free. Applications Eltex® MED PH23T630 is recommended for injection moulding of: Flexible lids Caps and closures Pharmaceutical & diagnostic packaging Eltex® MED PH23T630 can be sterilized with Eto-treatment or with Gamma radiation up till 50 kGy&&

Product Description
Supplier	INEOS
Generic	LDPE
Material Status	Commercial: Active
Features	Good flexibility,High liquidity,Quick molding cycle,Low density,Radiation disinfection,Ethylene oxide disinfection
Availabilitys	Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.923	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	22	g/10min	ISO 1133
Shrinkage rate	1.5 to 2.0	%

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D, injection molding	49		ISO 868
Tensile modulus	180	MPa	ISO 527-1-2
Tensile strain
fracture	130	%	ISO 527-2/50

IMPACT	Nominal value	Unit	Test method
Tensile impact strength	160	kJ/m²	ISO 8256/1A

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	49.0	℃	ISO 75-2/B
Vicat Softening Temp
A50	92.0	℃	ISO 306/A50

Process Conditions
injection	Nominal value	Unit	Test method
Processing (melt) temperature	180 to 230	°C
Mold temperature	10 to 40	°C
Injection speed	Fast

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.