| About |
|---|
| Recommended Applications: 105°C insulation compound designed for THW-LS with low acid gas. This product complies with the European Union Restriction on Hazardous Substances (RoHS) directive.&& |
| Product Description | |
|---|---|
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Features | Good liquidity |
| Availabilitys | North America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.45 to 1.49 | g/cm³ | ASTM D792 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| The rate of change in tensile strength in air | |||
| 136℃，168 hr | 6.0 | % | UL 1581 |
| The rate of change in ultimate elongation in air | |||
| 136℃，168 hr | -18 | % | UL 1581 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -17.0 | ℃ | ASTM D746 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 1.2E+14 | ohms·cm | ASTM D257 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Extreme oxygen index | 29 | % | ASTM D2863 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | ASTM D2240 | ||
| Shaw’s D | 49 to 55 | ||
| Shore D, 10 seconds | 41 to 47 | ||
| Tensile modulus | |||
| 100% secant | 10.5 | MPa | ASTM D638 |
| tensile strength | 14.5 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 230 | % | ASTM D638 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Unaged Dumbbell: .03 inch |
| 3. Air Aged Retention |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |