| About |
|---|
| Andur® 5000 DP is a Polyurethane (TDI) (PUR-TDI) product. It is available in North America.&& |
| Product Description | |
|---|---|
| Generic | PUR+TDI |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.16 | g/cm³ | |
| Water absorption rate | |||
| balance | 2.2 | % | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 31.7 | MPa | |
| 100% strain | 14.6 | MPa | |
| 300% strain | 25.2 | MPa | |
| Tensile strain | |||
| fracture | 310 | % | |
| tear strength | |||
| — | 80.6 | kN/m | ASTM D624 |
| cracking | 19 | kN/m | ASTM D470 |
| cracking | 21 | kN/m | ASTM D1938 |
| Compression deformation | |||
| 70℃，22 hr | 43 | % | ASTM D395 |
| Basho’s elasticity | 40 | % | ASTM D2632 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -30.0 | ℃ | DMA |
| Linear coefficient of thermal expansion | |||
| MD | 2.1E-4 | 1/℃ |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| NCO | 6.5 to 6.9 | % | |
| Uncured Properties | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | |||
| 100℃ | 1.14 | g/cm³ | |
| 70℃ | 1.16 | g/cm³ | |
| viscosity | |||
| 100℃ | 0.16 | Pa·s | |
| 70℃ | 0.58 | Pa·s |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 48 to 52 | ||
| Tensile modulus | 138 | MPa |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |