| About |
|---|
| Westlake EMAC® SP2404 is a 18.5% EMA copolymer designed for blown film, tie-layer, coextrusions and blending where flexibility and strength are important. SP2404 provides excellent elasticity and low temperature performance. Articles produced from SP2404 will exhibit very high C.O.F without addition of slip or anti-blocking agents.&& |
| Product Description | |
|---|---|
| Supplier | Westlake Chemical |
| Generic | EMA |
| Material Status | Commercial: Active |
| Features | Good flexibility,Copolymer,Low temperature toughness,Soft,High ESCR |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.941 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 2.5 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 39 | ASTM D2240 | |
| tensile strength | |||
| fracture | 12.7 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 740 | % | ASTM D638 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -73.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 60.0 | ℃ | ASTM D1525 |
| Melting temperature | |||
| DSC | 86.0 | ℃ | ASTM D3418 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |