About |
---|
TR Granules possess the characteristics of both thermosetting rubber and thermoplastic resin, which have been widely used to replace traditional vulcanized rubber such as NBR, BR, SBR, etc. TR Granules are compounded thermoplastic materials composed primarily of Styrenic Block Copolymer, supplied as granule to facilitate processing.&& |
Product Description | |
---|---|
Supplier | SHIDA |
Generic | SBS |
Material Status | Commercial: Active |
Features | Excellent Processability,Renewable resources |
Availabilitys | Asia Pacific |
Process Methods | Injection Molding |
Technical Data | |||
---|---|---|---|
PHYSICAL | Nominal value | Unit | Test method |
Density | 0.980 | g/cm³ | ISO 1183 |
elastic body | Nominal value | Unit | Test method |
---|---|---|---|
tear strength | 31 to 33 | kN/m | ISO 34-1 |
Supplementary information | Nominal value | Unit | Test method |
---|---|---|---|
Flex Resistance | > 50000 | GB/T 3903 | |
James Slip Resistance | ASTM D2047 | ||
Dry | 1.08 | ASTM D2047 | |
Wet | 1.05 | ASTM D2047 |
MECHANICAL | Nominal value | Unit | Test method |
---|---|---|---|
Shore hardness | |||
Shaw’s A | 55 to 75 | ISO 868 | |
tensile strength | 9.20 to 13.2 | MPa | ISO 527-2 |
Tensile strain | |||
fracture | 790 to 900 | % | ISO 527-2 |
Wear amount | 250 to 330 | mm³ | ISO 4649 |
Process Conditions | |||
---|---|---|---|
injection | Nominal value | Unit | Test method |
Barrel rear temperature | 150 to 200 | °C | |
Barrel middle temperature | 150 to 200 | °C | |
Barrel front temperature | 150 to 200 | °C | |
Nozzle temperature | 150 to 200 | °C | |
Mold temperature | 20 to 40 | °C |
Notes |
---|
1. Typical properties: these are not to be construed as specifications. |
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |