| About |
|---|
| HX-086AB is a fully-crosslinked thermoplastic elastomer(TPE) product. TPEs can be easily processed with general thermoplastic processing equipments. It has low compression set, good weatherability and excellent resistance to high temperature, chemicals, and ozone. Flexible PVC, rubbers (CR, NBR, EPDM etc.) can be replaced with TPE.&& |
| Product Description | |
|---|---|
| Supplier | LOTTE |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability,Good Dimensional Stability,High Heat Resistance,Ozone resistance,Solvent resistance |
| Availabilitys | North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.960 | g/cm³ | ASTM D792 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 87 | ASTM D2240 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 13.7 | MPa | ASTM D412 |
| 100% strain | 6.86 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 500 | % | ASTM D412 |
| tear strength | 49.0 | kN/m | ASTM D624 |
| Compression deformation | |||
| 70℃，72 hr | 30 | % | ASTM D395 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| -40℃ | 无断裂 | ASTM D256 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |