TECHNYL® PSB 231 NATURAL

About
TECHNYL® PSB 231 Natural is an unreinforced high transparency polyamide 6, for injection moulding. This grade offers good mechanical properties and high transparency till 2-2,5 mm of thickness. Due to its benefits, it is adequate for applications which request transparency at low thickness.&&

Product Description
Supplier	DOMO
Generic	PA6
Material Status	Commercial: Negative
Availabilitys	Europe,Africa & Middle East
Process Methods	Injection Molding

Technical Data

Process Conditions
Injection	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	225 to 230	°C
Temperature in the middle of the barrel	230 to 235	°C
Front temperature of material barrel	230 to 240	°C
Mold temperature	60 to 80	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.