| About |
|---|
| This compound is intended for use in medical and healthcare applications requiring excellent elastic properties.&& |
| Product Description | |
|---|---|
| Supplier | Teknor Apex |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | High pressure disinfection,Radiation disinfection,Ethylene oxide disinfection |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.908 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 3.5 | % | ASTM D995 |
| TD | 2.0 | % | ASTM D995 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 3.0 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Linear coefficient of thermal expansion |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 45 | ASTM D2240 | |
| tensile strength | 10 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 630 | % | ASTM D412 |
| tear strength | 38 | KN/m | ASTM D624 |
| Compression deformation | 13 | % | ASTM D395 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion molding conditions | Nominal value | Unit | Test method |
| Injection temperature | |||
| Rear barrel temperature | 140-160 | °C | |
| Central temperature of the barrel | 160-180 | °C | |
| Barrel front temperature | 170-190 | °C | |
| Mold temperature | 20-40 | °C | |
| Zone 1 temperature | 140-150 | °C | |
| Zone 3 temperature | 150-160 | °C | |
| Zone 5 temperature | 160-180 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |