| About |
|---|
| KYDEX® 6200 LTR is formulated for mass transit interior applications where SMP800C compliance is required. KYDEX® 6200 LTR is the next generation in our line of high performance thermoplastic sheet products for rail and bus interiors. It is a cost effective alternative to FRP due to its greater ease of fabrication. This product meets the recommended fire safety practices of both the Federal Transit Administration (FTA) and the Federal Rail Administration (FRA) for smoke emission and flammability when tested as per ASTM E-662 and ASTM E-162. Suggested Applications Seatbacks Window Reveal Bulkhead Components Ceiling Components Features Specifically designed for mass transit industries Compliant with SMP800C Meets flamespread and smoke density requirements for mass transit Excellent formability and fabrication quality Good definition Allows for tight tolerances Easy trimming&& |
| Product Description | |
|---|---|
| Supplier | Sekisui |
| Generic | PMMA+PVC |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Low smoke,Flame Characteristics,Good tunability |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Process Methods | Thermo forming |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.58 | g/cm³ | ASTM D792 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | ASTM D648 | ||
| 0.45 MPa, annealed | 82.2 | ℃ | ASTM D648 |
| 1.8 MPa, annealed | 71.1 | ℃ | ASTM D648 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Radiation plate flame spread index | Pass | ASTM E162 | |
| Smoke Developed | Pass | ASTM E662 | |
| toxicity | Pass | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 78 | ASTM D785 | |
| Tensile modulus | |||
| 3.18 mm | 2260 | MPa | ASTM D638 |
| tensile strength | |||
| Yield, 3.18 mm | 23.4 | MPa | ASTM D638 |
| Bending modulus | |||
| 3.18 mm | 2710 | MPa | ASTM D790 |
| bending strength | |||
| 3.18 mm | 42.6 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 4 mins |
| 3. SMP 800C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |