About |
---|
ALCUDIA® CA-7420B is stabilized with HALS (colourless), UV absorber and antioxidants. The main properties of these compound films are heat retention, high solar radiation resistance and light transmission. APLICATIONS Films for greenhouses and tunnels cover. 200 µm thickness, 1:2:1 three layers coextruded films, with ALCUDIA® CA-7420B in the middle layer and ALCUDIA® CA-7220B in the external layers, have a lifetime of the three years in geographical areas where maximum solar radiation is 160 Kly. For further information, contact to Technical Assistance and Development Department or Commercial Attention Service. Processing conditions should be optimized for each production line because of different rheological properties in coextruded structures.&& |
Product Description | |
---|---|
Supplier | REPSOL |
Generic | EBA |
Material Status | Commercial: Active |
Features | Inoxidizability |
Availabilitys | North America,Europe |
Process Methods | Film extrusion |
Technical Data | |||
---|---|---|---|
PHYSICAL | Nominal value | Unit | Test method |
Density | 0.926 | g/cm³ | ISO 1183 |
Melt Flow Rate | |||
190℃,2.16kg | 0.40 | g/10min | ISO 1133 |
Butyl acrylate composition | 8.0 | wt% | MA 173500 |
film | Nominal value | Unit | Test method |
---|---|---|---|
film thickness | |||
test | 200 | µm | |
tensile strength | |||
MD, fracture, 200 µ m, blow molded film | 21.0 | MPa | |
TD, fracture, 200 µ m, blow molded film | 21.0 | MPa | |
Tensile strain | |||
MD, fracture, 200 µ m, blow molded film | 550 | % | |
TD, fracture, 200 µ m, blow molded film | 600 | % | |
Drop hammer impact | |||
200 µ m, blow molded film | 1300 | g | ISO 7765-1 |
Elmandorf tear strength | |||
MD: 200 µ m, blow molded film | 10 | N | |
TD: 200 µ m, blow molded film | 12 | N |
optical performance | Nominal value | Unit | Test method |
---|---|---|---|
Haze | |||
200 µ m, blow molded film | 20 | % | ASTM D1003 |
Global Transmission of Visible Light(200.0 µm) | 91 | % | EN 13206 |
IR Absorption(200.0 µm) | 75 | % | EN 13206 |
Supplementary information | Nominal value | Unit | Test method |
---|---|---|---|
Notes |
---|
1. Typical properties: these are not to be construed as specifications. |
2. Blown Film |
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |