| About |
|---|
| Applications: Thermoform Die cut and seal Characteristics: Rigid, thermoformable High impact resistance Low moisture absorption Dimensionally stable Clear surface Abrasion resistance No plasticizers to migrate & cause embrittlement Resistance to hydrocarbons, chemicals, ozone Resistance to skin oils RF, ultrasonic and heat weldable High draw-down ratio.&& |
| Product Description | |
|---|---|
| Generic | TPU |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good Clarity,High impact resistance,Good Dimensional Stability,Good dissection,Low or no water absorption,Good wear resistance,Good Ultrasonic Properties,Ultrasonic soldering,Grease resistance,Ozone resistance,Solvent resistance,Welding,Hydrocarbons |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.20 | g/cm³ | ASTM D792 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile strain | |||
| fracture | 160 | % | ASTM D412 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ASTM D256 | ||
| -40℃，3.2mm | 59 | J/m | ASTM D256 |
| 23℃，3.2mm | 85 | J/m | ASTM D256 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 72 | ASTM D2240 | |
| tensile strength | 69.0 | MPa | ASTM D638 |
| Bending modulus | 2300 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 63 to 85 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |