| About |
|---|
| TOYOBO Urethane A3080A is a Polyurethane (Polyether based) (PUR-Ether) product. It can be processed by injection molding and is available in North America.&& |
| Product Description | |
|---|---|
| Supplier | TOYOBO |
| Generic | PUR-醚 |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.12 | g/cm³ | ASTM D792 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | 88.3 | kN/m | ASTM D624 |
| Compression deformation | 35 | % | ASTM D395B |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -65.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 90.0 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 82 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| yield | 39.2 | MPa | ASTM D638 |
| 100% strain | 5.39 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 510 | % | ASTM D638 |
| Taber abraser | |||
| 1000 cycles | 10.0 | mg | ASTM D1044 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |