| About |
|---|
| A soft, black, UV resistant thermoplastic vulcanizate (TPV) in the thermoplastic elastomer (TPE) family. This material is specially formulated to bond to thermoset EPDM rubber for corner molding, end caps and special applications requiring such adhesion to thermoset EPDM. This grade of Santoprene TPV is shear-dependent and can be processed on conventional thermoplastics equipment for injection molding. It is polyolefin based and recyclable within the manufacturing stream.&& |
| Product Description | |
|---|---|
| Supplier | Celanese |
| Material Status | Commercial: Active |
| Features | Renewable resources |
| Availabilitys | Europe,Asia Pacific,Latin America,Africa & Middle East ,North America |
| Process Methods | Multiple injection molding,Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Tensile Stress | |||
| 100% stretch | 2.3 | MPa | ISO 527-2/1A |
| Broken BRK | 9.2 | MPa | ISO 527-2/1A |
| Elongation at Break | 600 | % | ISO 527-1,2 |
| Shore hardness | 67 | ISO 868 | |
| 70℃ | 22 | % | ISO 815 |
| 125℃ | 48 | % | ISO 815 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 910 | kg/m³ | ISO 1183 |
| Process Conditions | |||
|---|---|---|---|
| Injection Molding | Nominal value | Unit | Test method |
| Melt Temperature | 215 | ℃ | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type 1 |
| 3. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |