ADMER™ AT2614E

About
ADMER™ AT2614E is a maleic anhydride grafted PE- based adhesive designed for double- and triple- bubble process. It shows high adhesion to PE, PA, EVOH, PP, PC and PET.&&

Product Description
Supplier	Mitsui
Generic	MAH-g-PE增容剂
Material Status	Commercial: Active
Features	Food contact compliance,Good bond
Availabilitys	Africa & Middle East ,Europe
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ASTM D1505
Melt Flow Rate
190℃，2.16kg	3.6	g/10min	ASTM D1238

IMPACT	Nominal value	Unit	Test method
Notched impact strength of cantilever beam	无断裂		ASTM D256

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	70.0	℃	ASTM D1525

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	38		ASTM D2240
tensile strength
fracture	27.0	MPa	ASTM D638
Tensile strain
fracture	> 500	%	ASTM D638

Process Conditions
Extrusion	Nominal value	Unit	Test method
Barrel 1 zone temperature	180 to 200	°C
Barrel 2 zone temperature	180 to 200	°C
Barrel 3 zone temperature	200 to 230	°C
Barrel 4 zone temperature	200 to 230	°C
Melt temperature	200 to 230	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.