| About |
|---|
| PermaFlex® 50 is a Thermoplastic Elastomer (TPE) product. It is available in North America. Characteristics include: Flame Rated Chemical Resistant Good Tear Strength Hydrolytically Stable Wear Resistant&& |
| Product Description | |
|---|---|
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Hydrolysis stability,Good tear strength,Good wear resistance,Good compressive strength,Solvent resistance,HB |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.24 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 240℃，2.16kg | 65 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 0.50 to 0.60 | % | ASTM D955 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ASTM D256 | ||
| -40℃ | 无断裂 | ASTM D256 | |
| 23℃ | 无断裂 | ASTM D256 | |
| Dart impact equipped with measuring instruments | 36.2 | J | ASTM D3763 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 202 | ℃ | ASTM D1525 3 |
| Melting temperature | 210 | ℃ |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 1.60 mm | HB | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 55 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| Fracture, -40 ℃ | 48.3 | MPa | ASTM D638 |
| Fracture, 23 ℃ | 48.3 | MPa | ASTM D638 |
| Tensile strain | ASTM D638 | ||
| Fracture, -40 ℃ | 900 | % | ASTM D638 |
| Fracture, 23 ℃ | 900 | % | ASTM D638 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type I |
| 3. Rate A (50°C/h) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |