TECOLITE KM-50BD

About
Good moldability and Good productivity. Provides suitable compounds and Superior cost performance. Kyocera Chemical’s Phenolic Molding Compounds “TECOLITE” have a good high voltage resistance and a good moldability. “TECOLITE” are designed for insulation boards and telecommunication parts. Moreover coloring compounds are possible. Therefore can select the most suitable compounds for parts.&&

About

Good moldability and Good productivity. Provides suitable compounds and Superior cost performance. Kyocera Chemical’s Phenolic Molding Compounds “TECOLITE” have a good high voltage resistance and a good moldability. “TECOLITE” are designed for insulation boards and telecommunication parts. Moreover coloring compounds are possible. Therefore can select the most suitable compounds for parts.&&

Product Description
Supplier	KYOCERA
Generic	酚醛树脂
Material Status	Commercial: Active
Features	Excellent Processability,HB
Availabilitys	Asia Pacific

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.41	g/cm³
Shrinkage rate
MD	0.70 to 0.90	%
Water absorption rate
balance	< 0.30	%

MECHANICAL	Nominal value	Unit	Test method
bending strength	88.0 to 108	MPa

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature	165	℃

Electrical performance	Nominal value	Unit
Dielectric strength	> 8.0	kV/mm
insulation resistance
After boiling	1.0E+8 to 1.0E+9	ohms
As Molded	1.0E+9 to 1.0E+10	ohms

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
0.71 mm	HB		UL 94

Notes
1. Typical properties: these are not to be construed as specifications.
2. Compression Molding
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.