| About |
|---|
| Daelim Po1y® LH-641 is a High Density Polyethylene product. It can be processed by rotational molding and is available in Asia Pacific or Europe. Applications of Daelim Po1y® LH-641 include containers, food contact applications and tanks. Characteristics include: Impact Resistant Rigid&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,High impact resistance |
| Availabilitys | Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.941 | g/cm³ | ASTM D1505 |
| Environmental stress | >500 | hr | ASTM D1693B |
| Melt Flow Rate | |||
| 190℃，2.16kg | 4.0 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | |||
| 119 | ℃ | ASTM D1525 | |
| Forming (melt) temperature | 200-280 | ℃ |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 290 | J/m | ASTM D256 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | 56 | R 级 | ASTM D785 |
| tensile strength | |||
| Yield, 23 ℃ | 21.6 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 800 | % | ASTM D638 |
| Bending modulus | |||
| 23℃ | 804 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |