| About |
|---|
| Product Description | |
|---|---|
| Supplier | Sciengy |
| Material Status | Commercial: Negative |
| Features | Corrosion Resistant,High Heat Resistance,Good flexibility |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1200 | kg/m³ | ISO 1183 |
| Forming shrinkage rate | 2.0 | % | GB/T 15585 |
| Water absorption rate | |||
| 23°C | 0.1 | % | ISO 62 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 40 | MPa | ISO 527 |
| elongation at break | 80 | % | ISO 527 |
| Bending modulus | 15 | GPa | ISO 178 |
| bending strength | 60 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Notch impact strength | |||
| V-shaped notch | 50 | KJ/m² | ISO 179 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | 90 | ℃ | ISO 75 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | V-1 | calss | UL 94 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 24 | kV/mm | IEC 60243 |
| Dielectric constant | 3.0 | IEC 60250 | |
| Dissipation factor | 0.002 | IEC 60250 |
| Process Conditions | |||
|---|---|---|---|
| Injection molding | Nominal value | Unit | Test method |
| Melt Temperature | 290-330 | ℃ | ISO 294 |
| Mold temperature | 120-160 | ℃ | ISO 294 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |