NuSil MED-4970

About
NuSil Technology’s restricted materials may be considered for use in short-term implant applications, 29 days or less, or for external applications. Liquid silicone rubbers, or LSRs, are elastomer systems reinforced with silica. They contain functional polymers of lower average molecular weight and viscosity when compared to high consistency rubbers (HCRs). They are typically supplied as two-component systems and formulated in a 1:1 mix ratio. Because their consistency is akin to petroleum jelly, they are often pumped with injection molding equipment to form molded components such as o-rings, gaskets, valves, seals, and other precision molded parts. LSRs are designed for liquid injection molding (LIM) processes which may utilize single or multi-cavity molds, or for overmolding processes. Originally designed for automated systems, they are developed with high volume applications in mind and benefit from their high strength. Comments: INJECTION MOLDING ELASTOMER&&

About

NuSil Technology’s restricted materials may be considered for use in short-term implant applications, 29 days or less, or for external applications. Liquid silicone rubbers, or LSRs, are elastomer systems reinforced with silica. They contain functional polymers of lower average molecular weight and viscosity when compared to high consistency rubbers (HCRs). They are typically supplied as two-component systems and formulated in a 1:1 mix ratio. Because their consistency is akin to petroleum jelly, they are often pumped with injection molding equipment to form molded components such as o-rings, gaskets, valves, seals, and other precision molded parts. LSRs are designed for liquid injection molding (LIM) processes which may utilize single or multi-cavity molds, or for overmolding processes. Originally designed for automated systems, they are developed with high volume applications in mind and benefit from their high strength. Comments: INJECTION MOLDING ELASTOMER&&

Product Description
Supplier	NuSil
Generic	硅橡胶,LSR
Material Status	Commercial: Active
Features	Good Rigidity,Fast Cure,Good coloring
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Liquid injection molding

Technical Data
THERMAL	Nominal value	Unit	Test method
Thermosetting components
Component A	按重量计算的混合比: 1.0
Component B	按重量计算的混合比: 1.0

Supplementary information	Nominal value	Unit	Test method
Cure System	Platinum
Extrusion rate	40.0	g/min

Uncured Properties	Nominal value	Unit
Density	1.16	g/cm³
Curing time
165℃	0.083	hr
storage stability
25 ℃	> 1400	min

Cured Properties	Nominal value	Unit
Shore hardness
Shaw’s A	70
tensile strength	8.62	MPa
200% strain	5.17	MPa
Tensile strain
fracture	300	%
tear strength	32.4	kN/m

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.