| About |
|---|
| U series resins are polymer alloys that are improved in resistance to oils and chemicals, the shortcoming of amorphous resins. They are transparent and have a greater moisture-blocking property than other resins having similar structures. They are also suitable for blow molding.&& |
| Product Description | |
|---|---|
| Supplier | UNITIKA |
| Generic | 多芳基化合物 |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Ethanol tolerance,Moisture resistance,Grease resistance,Solvent resistance,Amorphous |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.26 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD：3.0 mm | 0.80 | % | ASTM D955 |
| Water absorption rate | |||
| 24hr，3.18 mm | 0.15 | % | ASTM D570 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃，3.2mm | 110 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 110 | ℃ | ASTM D648 |
| Linear coefficient of thermal expansion | |||
| MD | 6.2E-5 | 1/℃ | ASTM D696 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 2.0E+16 | ohms·cm | ASTM D257 |
| Dielectric strength | 44 | kV/mm | ASTM D149 |
| Dissipation factor | |||
| 1 MHz | 0.015 | ASTM D150 | |
| Arc resistance | 120 | sec | ASTM D495 |
| Compared to the leakage tracing index | 232 | V | IEC 60112 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Transmittance | |||
| 3000 µm | 87.0 | % | ASTM D1003 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 125 | ASTM D785 | |
| tensile strength | 71.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 110 | % | ASTM D638 |
| Bending modulus | 2700 | MPa | ASTM D790 |
| bending strength | 103 | MPa | ASTM D790 |
| compressive strength | 86.0 | MPa | ASTM D695 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |