| About |
|---|
| OMIKRON FMS 30 R is a copolymer polypropylene filled with 10% of talc for injection moulding, high processability. It is available in black or coloured version. OMIKRON FMS 30 R is suitable for moulding of items requiring stiffness and dimensional stability well as good aesthetic.&& |
| Product Description | |
|---|---|
| Generic | PP copolymer |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Excellent Processability,Good surface appearance,Good Dimensional Stability,Copolymer,HB |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.00 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 9.0 | g/10min | ISO 1133 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 20.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| fracture | 40 | % | ISO 527-2 |
| Bending modulus | 1700 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ISO 180 | ||
| 0℃ | 7.5 | kJ/m² | ISO 180 |
| 23℃ | 14 | kJ/m² | ISO 180 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Accelerated Aging（150℃） | 6.3 | day | Internal Method |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 53.0 | ℃ | ISO 75-2/A |
| Vicat Softening Temp | 55.0 | ℃ | ISO 306/B |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Burning rate | < 100 | mm/min | FMVSS 302 |
| Flame retardant level | HB | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 2.0 | hr | |
| Barrel rear temperature | 210 to 260 | °C | |
| Barrel middle temperature | 210 to 260 | °C | |
| Barrel front temperature | 210 to 260 | °C | |
| Mold temperature | 40 to 60 | °C | |
| Injection pressure | 9.00 to 11.0 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |