| About |
|---|
| Product Description PP 412MK49 is specially developed for producing injection molded articles. This grade contains nucleating- & antistatic agents. It has medium flow properties , good impact resistance (even at low temperature) and good stiffness. Typical Applications PP 412MK49 can be used for houseware, toys, appliances and thin wall containers (Food and non food).&& |
| Product Description | |
|---|---|
| Supplier | SABIC |
| Generic | PP homopolymerization |
| Material Status | Commercial: Active |
| Features | Good Rigidity,High impact resistance,Nucleation,Food contact compliance,Moderate liquidity,Antistatic property,low-temperature impact resistance,Impact copolymer |
| Availabilitys | North America,Latin America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.905 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 45 | g/10min | ASTM D1238 |
| Shrinkage rate | 1.2 to 2.5 | % | |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ASTM D256 | ||
| -20 ℃, injection molding | 35 | J/m | ASTM D256 |
| 23 ℃, injection molding | 65 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 103 | ℃ | ASTM D648 |
| Vicat Softening Temp | 150 | ℃ | ASTM D1525 2 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 100 | ASTM D785 | |
| Tensile modulus | |||
| 1% cut, injection molding | 1500 | MPa | ASTM D638 |
| tensile strength | |||
| Yield, injection molding | 28.0 | MPa | ASTM D638 |
| Tensile strain | |||
| Yield, injection molding | 5.0 | % | ASTM D638 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 200 to 245 | °C | |
| Barrel middle temperature | 200 to 245 | °C | |
| Barrel front temperature | 200 to 245 | °C | |
| Mold temperature | 15 to 40 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Rate B (120°C/h) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |