| About |
|---|
| The Orgalloy® LE series is a flexible polyamide alloy. Outstanding properties: processability on PE screw, low moisture absorption, chemical resistance (no known solvents). The grades referenced: lower in rigidity than LE 6000 (900 MPa). Suited to the extrusion of tubes (hydraulic, pneumatic, painting, etc.)&& |
| Product Description | |
|---|---|
| Supplier | Arkema |
| Generic | PA6 Alloy |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good flexibility,Solvent resistance,Plasticizing,Low moisture absorption |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Profile extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.03 | g/cm³ | |
| Melt Volume Rate | |||
| 235℃，2.16 kg | 4.00 | cm³/10min | |
| Water absorption rate | |||
| Saturation, 23 ℃ | 5.5 | % | |
| Equilibrium, 23 ℃, 50% RH | 1.5 | % | |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | |||
| 23℃ | 82 | kJ/m² | |
| Charpy Unnotch Impact strength | |||
| 23℃ | — |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 86.0 | ℃ | |
| Melting temperature | 220 | ℃ | |
| Linear coefficient of thermal expansion | |||
| MD | 2.0E-4 | 1/℃ |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Compared to the leakage tracing index | — | V |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flammability level | |||
| 1.6 mm | HB | ||
| 3.2 mm | HB |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore D, 15 seconds | 57 | ||
| Tensile modulus | 850 | MPa | |
| tensile strength | |||
| yield | 28.0 | MPa | |
| Tensile strain | |||
| yield | 22 | % | |
| Nominal tensile fracture strain | > 50 | % |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 10°C/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |